Setup Procedures

To get started using your CB2 system, follow these procedures:

1. Place the BaseStation on a flat, dry surface, or in a desired rack-mounted location (rack screws not included). Wherever it is placed, ensure that the air input and output sections on the sides of the BaseStation are not restricted.
2. Connect the BaseStation to a compatible power source using provided power supply, but do not turn on power yet.
3. Attach the provided omni-directional antenna to the BaseStation. Follow these tips when determining a location for your BaseStation and antenna:

Antenna Positioning Tips:

• Every antenna has a certain pattern of coverage for which it is useful. The pattern of the BaseStation antenna needs to be focused in the desired coverage area to ensure best RF results. When possible, centrally position the omni-directional antenna in the middle of the desired coverage area.
• Higher is almost always better when placing antennas. The minimum acceptable application is to get the BaseStation antenna above head level.
• Maintaining a direct line of sight from the antenna to the Radio Pack is the best possible antenna scenario.
• Always keep antennas away from the following:
• Large metal objects. Stay at least two feet away from these.
• Large containers of liquid. Most liquids are intense RF absorbers.
• Confined spaces. Don’t set up antennas in rooms or areas with RF obstacles. Wide open spaces are good. Stay two to four feet away from walls or ceilings.

1. Power ON the BaseStation via its power switch.
2. Power on your Radio Packs. If already paired, they will log in and be ready for use.
• If your Radio Packs have not been paired to your BaseStation, see Pair Radio Packs for instructions on setting up and using Radio Packs with your system.
• If your Radio Packs do not have batteries installed, see Install Radio Pack Batteries. (You can also see Charge RP Batteries for more information on that topic.)
3. Proceed with connecting any hardwire connections to the BaseStation, if applicable.

   TIP: Always confirm that the non-Pliant intercom system and the CrewCom CB2 wireless system are functioning properly separately before connecting them together.

   • If connecting a 2-wire intercom system, connect it to the 2-wire intercom ports(s) on the back of the BaseStation. For full connection and configuration instructions, see 2-Wire Intercom Connectivity.
   • If connecting a 4-wire intercom system, connect it to the 4-wire intercom port(s) on the back of the BaseStation. For full connection and configuration instructions, see 4-Wire Intercom Connectivity.

   Note: The 2-Wire and 4-Wire ports on a CB2 BaseStation cannot be used simultaneously.

Related Topic(s)

Advanced System Setup