Relays

Relay Setup

To connect and enable relays to external General Purpose Output (GPO), connect any (or all) of the relays via the DA-15 Relay connection on the back of the CU. Then, configure the connection via CrewWare.

Only the Stage Announce relay may be enabled/disabled from the CU's Wired Settings menu. (See Stage Announce for more information about this menu.)

Configure the triggers for each relay via CrewWare's Devices Tab - Control Units.

CrewCom includes five General Purpose Output (GPO) contact closures for interfacing with other external devices (the Stage Announce (SA) Relay and four additional GPO relays). The user has access to both the normally open and the normally closed contacts for each relay. The rated load for all relay contacts is 0.3 Amp at 125VAC, 1 Amp at 30VDC.

The following pinout is for the DA-15 connector on the rear of the CU:

DA-15 Female Pin Out

Relay Pin Diagram